Sound familiar?Falls View
- The call
- The rental turns over every few months and each time you drive across town to swap keys, then wonder whether copies were made. A lock with codes you can set and erase from your phone would end that cycle.
In plain words
A smart lock fitted by a locksmith keeps a way in that works when the battery or network fails, a mechanical key on many models or an external battery contact on key-free ones. Most keypad deadbolts keep a conventional keyway, rekeyed during the visit so a fresh key operates it and the old one retires. Some models instead add small outside terminals where a nine-volt battery can wake a dead lock long enough to enter a code. The technician tests whichever route the model provides, shows the low-battery warning, and explains what the lock does if the internet goes quiet.
Smart Lock Installation · Falls View
How the visit goes
Scene 1
Storm doors, sun and weather on the entrance
The outside of the lock lives in the weather, so the locksmith looks at what the entrance throws at it. A storm door with full glass can turn the space between the doors into an oven on a July afternoon, and electronics have a temperature ceiling; a vented storm door or a model rated for that exposure solves it. A keypad that faces prevailing wind collects driving snow and freezing rain, which argues for a covered entry or a lock with a shielded touch surface. Salt spray from a nearby driveway attacks finishes over time. None of these rule out a smart lock; they steer the choice of model, finish and mounting.
Scene 2
Rekeying the override so the old key retires
Most keypad deadbolts keep a small conventional backup cylinder, and leaving it on the old key would undo half the point of the upgrade. The locksmith removes it, slides the plug out with a follower, repins it to a fresh combination, then cuts and tests new keys. Where the household wants one key for everything and the cylinders share a compatible keyway, the back and side doors are rekeyed to the same combination so a single key runs the override and the mechanical locks alike. Some makers reset the cylinder with a tool and the new key rather than by repinning; the method changes, the outcome is the same. The old key no longer opens any cylinder that was rekeyed.
Scene 3
Keeping the lock healthy through the seasons
A smart lock asks for a little seasonal attention and rewards it. In spring and autumn, check that the bolt still glides with the door closed and no hand on it; a door that has swollen or dropped starts to strain the motor before it stops working, and a hinge screw or strike adjustment then is far easier than a call later. Keep the keypad free of ice and grit, wipe salt film off the exterior in winter, and use only a dry lubricant on the override cylinder, never oil. Accept firmware updates when the app offers them. If the lock starts to sound laboured, that is its way of asking for a look.
In the van
- Hand screwdrivers, Phillips and Torx
- Mechanical override cylinder and repinning kit
- Hinge shims and long hinge screws
- Thick-door extension kit
- Hole saw, spade bit and drilling jig
What shapes the quoteDrummond Heights Locksmith Co.
- Type of smart lock chosen
- A keypad deadbolt, a Bluetooth model, a Wi-Fi model with a built-in radio or a lock that joins a home hub each sit at a different point on the hardware side of the quote, before any labour is counted.
- Rekeying the override cylinder and other locks
- Repinning the smart lock's backup cylinder to a new key, cutting the keys and bringing the remaining mechanical locks onto the same key are each counted per cylinder and per key.
- Retrofit versus full replacement
- An interior-only unit that turns your existing deadbolt involves less door work than a complete new deadbolt with a keypad outside, and the two are quoted differently in both hardware and time.
FeesSame any hour
Short answers to common questions
Will a smart lock fit my existing door?
Most residential doors have the standard preparation these locks are designed around: a large hole for the lock body, a smaller one in the edge for the bolt, and a thickness between roughly 35 and 45 millimetres. The locksmith measures all three plus the backset before recommending a model. Thicker doors take an extension kit, thin or glass-panelled doors and older doors with a mortise pocket call for a particular model or some preparation, and all of that is sorted out before the box is opened.
Can a smart lock go on a patio door, a side gate or a multipoint door?
Some can, and the locksmith will say which. Sliding patio doors use a hook or a pin rather than a deadbolt, so they take purpose-made electronic latches rather than a standard smart deadbolt. Multipoint doors, common on newer fibreglass and steel entries, lock at several points with one lever; a growing number of smart handles are built for them, and compatibility with your specific gearbox is checked first. Gates take weather-rated keypad locks designed for outdoor posts.
Do I still get a key?
In most cases, yes. The majority of keypad deadbolts keep a conventional cylinder behind or beside the keypad, and the locksmith rekeys it during the visit so a fresh key works and the old one is retired. A few designs have no keyway at all and rely on the keypad plus an emergency power contact instead. Which you prefer is part of choosing the model, and either way the fallback route is tested before the locksmith leaves.
Change or Rekey Locks
- Deadbolt InstallationThe front door has a handsome lever and a keyed knob, and that is all.
- Lock Replacement & UpgradeThree teenagers, a dog walker, a cleaner and one house key that keeps going missing.
- Vintage Mortise Lock ServiceYou bought a house with its original hardware and a bag of loose keys.
- Gate & Building Entry LocksEvery time the courtyard gate closes, it slams hard enough to rattle the fence panels, and the deadlatch never quite drops into…
- Mailbox Lock ReplacementAfter a winter of road spray and salt, the little lock on the mailbox door has gone stiff, then gritty, then almost immovable.
Falls Viewinformation
NiagaraOntario
Smart Lock Installation · Niagara Falls, Chippawa, Drummond Heights
- Town
- Falls View, Niagara
- In business
- 33 years
- Hours
- Open 24/7
- Nights, weekends and holidays, same fees
- Phone
- (289) 271-0790
- Visits
- On-site assessment preferred. Request a visit or call.
2021 census: what it means at the door
Every square is one home in a hundred.
- 61 in 100 homes · older homes
- 66 in 100 homes · mostly houses
- About 61% of homes in Niagara Falls were built in 1980 or earlier, according to the 2021 Census.Layers of paint build up on older doors and frames, and a lock that seemed to fail is sometimes a latch glued shut by the last coat. Part of the visit in an older area is freeing hardware, cleaning the edges and checking the door swings true.
- Single-detached houses make up about 66% of homes in Niagara Falls (2021 Census).A house has its own front door and its own frame, with nothing shared. That means the homeowner decides everything: the cylinder grade, the strike, the finish, whether to add a smart lock. The locksmith lays out the options and the household picks.
On-site assessment
Request a visit.
You have just taken possession of the house and the previous owners handed over a keypad deadbolt with a code nobody wrote down and an app account you cannot get into.
(289) 271-0790, open 24/7.